|
|
Post by rob52 on Jan 17, 2018 16:04:23 GMT -5
Does anyone have a Hi Power Sear Lever Type 1 that they don't need? I've tried Numrich, Midwest Gun Works, Brownells, and MidwayUSA without success. They're all backordered, out of stock, etc.
Just PM me if you can help.
Rob
|
|
|
|
Post by Bob Reed on Jan 17, 2018 18:14:35 GMT -5
Hello, Rob,
If you don't find one, you can make one outta a Type II Lever by grinding the paddle off. Just go slow and don't overheat the part. Or cut the paddle off with a small cut-off wheel and then grind and/or file the remaining edge down and re-contour the end of the lever. Again, go slow and don't overheat the part.
|
|
|
|
Post by ToddSig on Jan 17, 2018 19:07:21 GMT -5
|
|
|
|
Post by rob52 on Jan 17, 2018 21:15:00 GMT -5
Bob Reed and toddsig:
I thank you both for your suggestions. From the standpoint of ease, I will go with toddsig's recommendation first. I actually have a FEG that I looked at, but my mind said "Browning." And, I had looked at the type II lever and thought "gee, so close to what I need, but it has that xxxx big blade on it." I never thought of cutting it to fit even though I compared my newer and older Hi Powers.
I'm glad that you two provided common sense approaches to this problem.
Again, I thank you both.
Rob
|
|
